Thread Grafting New Roots onto Bonsai.

Threadgrafts are by far the easiest and most reliable grafts available to the bonsai enthusiast. Normally used to create new branches on a bonsai, a young, pliable shoot is threaded through the trunk of the tree.
As the shoot grows and fattens, the cambium layers of the shoot and the trunk are forced together and a join or graft is made.
Threadgrafts can also be used to attach new roots to a bonsai. With the English Hawthorn (Crataegus monogyna) below, a new root is required to improve the nebari (rootspread) of the tree and this is provided by thread grafting a young Hawthorn seedling.
For more details on the subject of threadgrafting, please visit:'Threadgrafting Bonsai' 
A second useful and related article is ‘Approach Grafting New Roots’; both threadgrafting and approach grafting new roots are equally viable techniques and should be seen as techniques that can be used individually or in conjunction with each other. 
Thread Grafting New Roots onto Bonsai
The roots of the Hawthorn immediately after collection. As is fairly typical of this species with its deep-growing tap roots, there were few fine roots in the rootball that I collected.

Pictured here is the rootball at the time of collection. The tree was planted into an inorganic soil mix with a little added sphagnum moss.
Thread Grafting New Roots onto Bonsai
3 years later, the same rootball is pictured after rootpruning.

The nebari and rootspread is developing well though the lateral surface roots are very straight and untapered; this will be improved over the years by selective pruning to increase ramification of these roots.

Thread Grafting New Roots onto Bonsai 

When the tree is repotted it becomes obvious that the areas either side of one of the old thick taproots is ugly and bare.

There are a number of ways of introducing new surface roots; some owe much to luck. Threadgrafting a new root is a relatively quick and sure-fire way to improve the nebari.
Thread Grafting New Roots onto Bonsai

The seedling used for a threadgraft must be of the same genus as the parent tree but it is also preferable that it is of the same species. Different species (such as Acer campestre (the field maple) and Acer palmatum (Japanese maple) will graft together but the bark colours and rate of growth are ill-matched. This will cause the graft to look artificial in future years.

It is important that threadgrafting is carried out before the seedling starts to bud out in the Spring as at this time the leaf buds swell and are easily dislodged as the seedling is threaded.

The seedling is bare-rooted and any side branches are removed.
Thread Grafting New Roots onto Bonsai 

A hole is drilled through the trunk of the bonsai.

Though it is preferable that the hole for the threadgraft is made from the entry side to ensure it's position with absolute accuracy, this tends to be difficult if the tree is already potted up.

Try to make the exit hole for the graft in a position where it will be hidden from view (facing the back of the tree).

Use a wood drill bit that is slightly larger than the diameter of the seedling so the seedling can be introduced through the hole without damage. However, making the hole too big will increase the time needed for the graft to take.
Thread Grafting New Roots onto Bonsai

If a large diameter drill bit is needed for the seedling to fit, use thinner bits to make an initial pilot hole and gradually widen the hole with larger bits until the correct diameter is reached.

Ensure that the drill bit is fixed very firmly in the chuck; wet wood has a lot of 'drag' and there is potential for the drill bit to come out of the drill and become stunk inside the trunk.

Thread Grafting New Roots onto Bonsai 

After drilling, the seedling is threaded through the hole....

Thread Grafting New Roots onto Bonsai

.............until it is finally in position.

As can be seen in this picture, the seedling has been selected for matching bark colour and the way the taproot naturally bifurcates (splits into two) creating a more natural surface root

Thread Grafting New Roots onto Bonsai 

The roots of the seedling are covered with soil and the holes in the main trunk sealed with cut paste to encourage rapid healing.

Thread Grafting New Roots onto Bonsai

The seedling will be encouraged to grow strongly this year; the greater its growth, the faster the graft will take.

When the seedling and the main tree have visibly joined and healed together, the upper part of the seedling will be gradually pruned down until all that is left are its roots growing into the main tree.

Patience is necessary; at the very earliest this separation will take place in a year's time.

 Hawthorn threadgraft

The main tree and the threadgraft July 2005
Hawthorn rootgraft

Update: December 2006. By August of this year, the threadgrafted shoot had grafted tightly into position. The top section of the threadgrafted seedling was pruned away leaving its base as part of the main tree.

Hawthorn rootgraft

The Hawthorn bonsai itself; December 2006. Here is another example of threadgrafting roots; this time on an Acer campestre/Field Maple.

Acer campestre/Field Maple

Acer campestre, as with most Acer species, exhibit strong root growth. Though there are three strong lateral/surface roots that are being to develop some division and taper; there are also two large gaps in between these three surface roots.

With many maples, new roots could be encouraged by simply scoring the bark of the trunk, however, if new roots were to emerge, they would require many years of strong growth to thicken as much as the three existing surface roots.
Instead, three young, pencil-thick Acer campestre saplings are thread-grafted into the gaps in the nebari. These will take much less time to become nearly as thick as the existing surface roots

.Acer campestre/Field Maple 

In this image the three saplings (new roots) have been threadgrafted into position.
A couple of reed-sticks have been lodged across the roots to ensure the new roots keep their positions when they are covered back over with soil.

Notice that the exisiting larger roots have been pruned to ensure a smooth transition into the smaller secondary surface roots; just as you would ensure a smooth transition between the branch sections of a bonsai.

Acer campestre/Field Maple
www.zanox.com

Custom Search
Crea le tue foto ed immagini come Slideshow per eBay, Netlog, MySpace, Facebook o la tua Homepage!Mostrare tutte le immagini di questo Slideshow


If you liked this article, subscribe to the feed by clicking the image below to keep informed about new contents of the blog:

Other Similar Posts That Could Interest You By Fausto Baccino

Do you ever wonder what happens when your readers reach the end of your posts? What do they click on? Where do they go next? What if you’ve piqued a reader’s interest and left them wanting more, but don’t give them the option to do so? Now, we’ll search your site for similar posts you’ve written and display a “Related” section at the end of every post, like this:
    Blogger Comment
    Facebook Comment

0 commenti :

Post a Comment